yourselfkvm.blogg.se - Honeywell galaxy alarm code 0680

Please note time and date changes will not be seen in the alarm logs. Make sure it’s set to Direct Access.Įscape all the way out of engineer mode, this will then learn the DualCom on the bus line and will add Com Mod 4. (56.4.3.1) Enter 1 = Access period make sure it’s set to Full.(56.4.2.4) Enter the last 6 digits of the Connection ID found on M Base.

Activate/deactivate any alarm groups you require (As default: 08 = Omit, 10 = setting, 13 electrical status are all turned OFF).

Enter engineer mode (112233 or 1122 Default code).

Enter panel programming (12345 or 1234 Default code).

Once the reboot has completed go to CSL My Base and change the panel type on the device to Honeywell-Galaxy2-RS485’.

(Display will show N – C – R then reboot)

The DualCom Pro will go through its power-up/registration process which will take approximately 2-3 minutes.

Connect the DualCom Pro directly to the Galaxy’s 485 – 3 wires A,B, RTN(-) for Pro).

Connect power to the DualCom using AUX supply from the panel.

Connect the aerial(s) provided to the DualCom Pro.

Place the Galaxy panel in engineer mode.

Panel Connection Information Manufacturer

01 Event(s) >.See Galaxy Troubleshooting & G2 - Specific Programming below This will then show a message ‘Status unset. To identify what the specific alarm fault problem is, you need to Enter your code into the key pad and press.

In the case of a power cut, you see a ‘Alert! Enter Code’ message on your Honeywell Galaxy alarm keypad – indicating that you have some kind of fault on your alarm system (but not specifying what the problem is). If you’ve had a power cut in your property and you have no power to your ADT Honeywell Galaxy alarm system, then this will affect your alarm – and if you have an old battery, make cause you system to go off / ring. ADT Honeywell Galaxy Alarm Power failure problem